Course Content
MEASUREMENT
(i) International System of Units, the required SI units with correct symbols are given at the end of this syllabus. Other commonly used system of units - fps and cgs. (ii) Measurements using common instruments, Vernier callipers and micro-metre screw gauge for length, and simple pendulum for time. Measurement of length using, Vernier callipers and micro-metre screw gauge. Decreasing least-count leads to an increase in accuracy; least-count (LC) of Vernier callipers and screw gauge), zero error (basic idea), (no numerical problems on callipers and screw gauge), simple pendulum; time period, frequency, graph of length l versus T2 only; slope of the graph. Formula T=2.π.gl [no derivation]. Only simple numerical problems.
0/17
QUIZ – MEASUREMENT – PRELIMINARY TEST
44:00
MEASUREMENT – SUPPORT MATERIAL – UNITS
03:48
MEASUREMENT AND EXPERIMENTATION – SUPPORT MATERIAL – FUNDAMENTAL UNITS
05:00
MEASUREMENT AND EXPERIMENTATION – SUPPORT MATERIAL – VERNIER CALLIPERS
06:00
MEASUREMENT AND EXPERIMENTATION – SUPPORT MATERIAL – SCREW GUAGE
05:00
MEASUREMENT AND EXPERIMENTATION – SUPPORT MATERIAL – SIMPLE PENDULUM
01:21
QUIZ – MEASUREMENT – UNITS AND QUANTITIES
01:00:00
QUIZ - MEASUREMENT AND EXPERIMENTATION
01:36:00
QUIZ - EXERCISE C - MEASUREMENT OF LENGTH
13:00
QUIZ – EXERCISE B – DERIVED UNITS
36:00
QUIZ - EXERCISE C - MEASUREMENT OF LENGTH
44:00
MEASUREMENT AND EXPERIMENTATION – CORE CONCEPT – INTRODUCTION
00:02
MEASUREMENT AND EXPERIMENTATION – CORE CONCEPT – SYSTEM OF UNIT IN S I SYSTEM
11:37
MEASUREMENT AND EXPERIMENTATION – CORE CONCEPT – UNIT OF MASS
03:31
MEASUREMENT AND EXPERIMENTATION – CORE CONCEPT – UNIT OF TIME
04:42
MEASUREMENT AND EXPERIMENTATION – CORE CONCEPT – UNITS OF LENGTH
04:42
MEASUREMENT AND EXPERIMENTATION – CORE CONCEPT – GUIDELINES FOR WRITING THE UNITS
03:45
EXPERIMENTATION
STD IX – MEASUREMENT AND EXPERIMENTATION – (Online)
Previous
Next
0% Complete